$12.50
Corner Iron reinforces the inside corner of the dock frame.
Mostly needed on a section that is resting on the J-Brackets for stationary docks or to reinforce corners and stringers on floating docks that are under a lot of torque due to wind, current and wave action.
| Weight | 1 lbs |
|---|---|
| Dimensions | 10 × 4 × 4 in |
Only logged in customers who have purchased this product may leave a review.
The actual measurement from outside edges is 1-7/8″ or 1.9.” However, it is known as “inch and a half schedule 40 Galvanized Pipe”. This is available at most hardware and plumbing stores. We additionally offer it for curbside pickup at … Read More
Marine grade aluminum
Requires two 3/8 bolts
In a marina, you have boat slips. The docks between boats are called finger docks. These dock sections are often very twisty at the end. If they are made out of wood, the boards flex enough they feel tipsy. The … Read More
Marine Grade Aluminum
10″ Long
4.5″ Tall
Holes are 3/4″ in from edge & 2 3/4″ from base
Requires 3/8″ Carriage Bolts for mounting
This bolt and nut is used to join floating dock sections. Tighten them up all the way into the nylock portion of the nut. To prevent noise, do not tighten the hinge plates together. (8 Per Pack)
Dock Pipe Leg Foot with a set screw for vertical adjustment. Pipe can pass through the foot into the ground while the foot prevents the leg from pushing deeper when weight is added. Dock feet are not always needed on rocky lake bottoms but more commonly used on mud and sand. Foot plate size is 9.5″ x 9.5″
Reviews
There are no reviews yet.