4×4 Post Bracket #9069A
Marine Grade Aluminum
10″ Long
4.5″ Tall
Holes are 3/4″ in from edge & 2 3/4″ from base
Requires 3/8″ Carriage Bolts for mounting
Corner Socket #4050
Bolts to a wood dock frame and fits 1 7/8″ OD Pipe. (Schedule 40 Galvanized Pipe) Flip upside down for opposite side of dock. To avoid confusion when buying pipe that fits in this dock part “4O5O”, the industry standard … Read More
Pipe Bracket (2 Pack) #4071
Dock Pipe Bracket bolts to the 2×6 dock frame and has set screws for height adjustment on 1.5″ schedule 40 pipe leg.
J Bracket Connector #9067 (2 Pack)
Connect stationary dock sections with these brackets. The Bolt provided is to clamp the resting section on the J Bracket. The diagonal shaped bolt holes allow height adjustment up to one inch between sections as some lumber varies in size. … Read More
Flush Mount Pipe Bracket #4183
Marine Grade Aluminum
Requires four 3/8″ carriage bolts
Fits 1.5″ schedule 40 Pipe
Corner Pipe Bracket #4059
Marine grade aluminum
Use two 3/8″ carriage bolts.
4.5″ tall
2×4 Rail Post Clamp (4 pack) #4051
Marine grade aluminum
Requires two 3/8 bolts
4×4 Post Foot #4069F
This is a foot that mounts to the lower end of a 4×4 post leg. The post can be pointed on the base and pounded into the ground until the plate meets the surface.
Bolt Kit 3/8″ Carriage #9280 (6 Count)
Six Galvanized Carriage Bolts Nuts and Washers 3/8″ x 2.5″
Corner Iron 90º #6027A
Corner Iron reinforces the inside corner of the dock frame. Mostly needed on a section that is resting on the J-Brackets for stationary docks or to reinforce corners and stringers on floating docks that are under a lot of torque due … Read More
Pipe Foot (2 Pack) #4180
Dock Pipe Leg Foot with a set screw for vertical adjustment. Pipe can pass through the foot into the ground while the foot prevents the leg from pushing deeper when weight is added. Dock feet are not always needed on rocky lake bottoms but more commonly used on mud and sand. Foot plate size is 9.5″ x 9.5″